Details
-
Improvement
-
Resolution: Not A Bug
-
Minor
-
None
-
None
Description
would be possible to collect the measurement in dBm dell powerconnect switches ? Today this feature is already available in observium in cisco routers .
in command line this command is:
RS - BKB - GVR - 001 - SW- 001 # show ports Fiber - optical- transceiver
Input output
Port Temp Voltage Current Power Power TX LOS
[ C ] [ Volt ] [ mA ] [ dBm ] [ dBm ] Fault
-----------------------------------------------
1/g48 31.5 3,348 29.8 -4,711 -8,918 No No
1/xg1 39.4 3,301 31.5 3,418 -19,508 No No
1/xg2 47.6 3,277 37.3 1,838 -18,239 No No
Temp - Internally Measured temperatures transceiver .
Voltage - Internally Measured supply voltage .
Current - Measured TX bias current.
Output Power - Measured optical output power relative to 1mW .
Input Power - Measured optical power received relative to 1mW .
TX Fault - Transmitter fault .
LOS - Loss of signal .
RS- GVR - BKB -001 -001 -SW #
Attachments
Activity
I have stacks of Powerconnect 6248P, they do not expose this through SNMP as far as I've seen, unfortunately 
if you want I can provide access to equipment for testing
This is only possible if the sensors are exposed in SNMP. It's only likely to be added if one of the development team have access to a device with the sensors.
Vendor doesn't expose this data in SNMP.