Details
-
Bug
-
Resolution: Fixed
-
Minor
-
None
-
None
-
None
-
None
Description
Hello,
I have a stack of switches Cisco C9500.
Observium has an active alarm about "Stack is redundant"(attached screenshot) but stack is full redundant.
sw38-acc-3t#show redundancy
Redundant System Information :
------------------------------
Available system uptime = 38 minutes
Switchovers system experienced = 0
Standby failures = 0
Last switchover reason = none
Hardware Mode = Duplex
Configured Redundancy Mode = sso
Operating Redundancy Mode = sso
Maintenance Mode = Disabled
Communications = Up
Current Processor Information :
-------------------------------
Active Location = slot 1
Current Software state = ACTIVE
Uptime in current state = 38 minutes
Image Version = Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.12.4, RELEASE SOFTWARE (fc5)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2020 by Cisco Systems, Inc.
Compiled Thu 09-Jul-20 21:42 by mcpre
BOOT = bootflash:packages.conf;
CONFIG_FILE =
Peer Processor Information :
----------------------------
Standby Location = slot 2
Current Software state = STANDBY HOT
Uptime in current state = 34 minutes
Image Version = Cisco IOS Software [Gibraltar], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.12.4, RELEASE SOFTWARE (fc5)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2020 by Cisco Systems, Inc.
Compiled Thu 09-Jul-20 21:42 by mcpre
BOOT = bootflash:packages.conf;
CONFIG_FILE =
Attachments
Activity
| Status | Original: Resolved [ 5 ] | New: Closed [ 6 ] |
| Attachment | New: redundant_error.PNG [ 18209 ] |
| Resolution | New: Fixed [ 1 ] | |
| Status | Original: In Progress [ 3 ] | New: Resolved [ 5 ] |
| Comment |
[ Please make and attach additional information about the device: * full snmp dump from device: {noformat} snmpwalk -v2c -c <community> --hexOutputLength=0 -ObentxU <hostname> .1 > myagent.snmpwalk snmpwalk -v2c -c <community> --hexOutputLength=0 -ObentxU <hostname> .1.3.6.1.4.1 >> myagent.snmpwalk {noformat} _If device not support SNMP version 2c, replace -v2c with -v1._ * If you have problems with discovery or poller processes, please do and attach these debugs: {noformat} ./discovery.php -d -h <device> ./poller.php -d -h <device> {noformat} * additionally attach device and/or vendor specific MIB files {color:#505F79}_Note, this comment is added automatically._{color} ] |
| Attachment | Original: myagent.snmpwalk [ 18140 ] |
| Status | Original: In Review [ 10101 ] | New: In Progress [ 3 ] |
| Assignee | Original: Adam Armstrong [ adama ] | New: Mike Stupalov [ landy ] |
| Status | Original: Pending Response [ 10000 ] | New: In Review [ 10101 ] |
| Attachment | New: myagent.snmpwalk [ 18140 ] |
| Status | Original: Open [ 1 ] | New: Pending Response [ 10000 ] |